HP PSC 2410XI PHOTOSMART SCANNER WINDOWS XP DRIVER DOWNLOAD

HP PSC 2410XI PHOTOSMART SCANNER DRIVER DETAILS:

Type: Driver
File Name: hp_psc_30966.zip
File Size: 30.5 MB
Rating:
3.18
10 (3.18)
Downloads: 9
Supported systems: Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP, Other
Price: Free* (*Free Registration Required)

Download Now
HP PSC 2410XI PHOTOSMART SCANNER DRIVER



I'm trying to find someone with hp psc 2410xi photosmart scanner disk I can check it against. I had the same problem; After power failure, the scanner head kept grinding and the printer would fail to start properly. I tried several of the reset remedies suggested here, including cleaning the internal scanner glass. Initially, no luck. I finally tried something different.

It is a hot and humid summer right now, so I took a hair drier and blew hot air into the scanner unit for a minute to remove hp psc 2410xi photosmart scanner humidity that might be inside. I don't know what combination did the trick, but perhaps the hair drier trick might work for someone else.

I also had the same problem with the flashing on light and the hourglass on the LCD. Holding the cancel button down didn't work. Took it apart and cleaned it, and lubricated the scanner carriage shaft and hp psc 2410xi photosmart scanner carriage to half way point as suggested and started back up but this also didn't work.

HP PSC 2410 Photosmart All In One Repair

I then did a partial re-set of the unit by unplugging it, holding down the pound key and the 3 key and hp psc 2410xi photosmart scanner back in. When the LCD showed the partial re-set I let go of the buttons. It went through its re-set and start up and went right to printing a test page and it worked fine after that. Hope this might work for some of you. I just got one of these printers xi for free--because of the same problem--hourglass just sit's there--also after doing all the reset bit and head moving--still didnt fix it--well at this point I figured it's already broke lets take it appart. I removed the rear paper jam door and found two screws--so I removed them and pulled down on the trim piece--removing it--and low and behold I found that the ribbin cable top one on board was loose--I unpluged both ribbins and reseated themsure enough it started working scanner light comes on now at initilization hp psc 2410xi photosmart scanner fine now and it was free!!!.

My PSC for Mac was working fine for two years. Now when I try to print, the desktop icon gets a red exclamation mark on it and the document stays in the que and won't print.

I have re-installed the latest software and the problem wasn't resolved. There is ink in the cartridges and I can print a test page but not a document.

HP PSC 2410XI PHOTOSMART SCANNER DRIVERS FOR WINDOWS

hp psc 2410xi photosmart scanner Any ideas? Moving the scanner head fix. I had to go in, too. Busted a couple of pieces on the way, but hey, its a psc so it deserved to be injured. On my first run, I slid the scanner head to the half way point, but it started grinding when it returned to the right side.

Hp psc 2410 photosmart all-in-one

I then slide it all the way over to the left and fired it up. Oh, happy day. It works again. Could the copy button be stuck? Remove the control panel overlay it prys off hp psc 2410xi photosmart scanner see if the problem goes away. Read your response.

HP PSC Photosmart Printer drivers - Download

Can you elaborate on item 7. While you are at it clean the underside of the glass and the white strip on the right. I too, have the dreaded grinding stuck scanner. After cleaning underside of scanner glass and white strip, make sure you do not smudge or leave fingerprints on white strip or underside of glass when putting back together. Pressed 3 and at the same time you plug in the power and hp psc 2410xi photosmart scanner buttons after power on to reset.

It worked! I had already bought a new printer, and decided to move the photosmart 24l0 to another room just to use for coping and faxing. Plug it up and power came on. However, when leaving the room, I turned the light switches off, and that turned the power off to the unit, hp psc 2410xi photosmart scanner when I turned the light switch on, the unit came back on stuck grinding again. Took apart again, cleaned, moved printer head back to middle, and restarted fine. I think these units cannot take any type of power surge when the unit is on.

HP PSC 2410XI PHOTOSMART SCANNER DRIVERS FOR WINDOWS DOWNLOAD

If I keep it unplugged and plug it in only when I use it, making sure there are no power interuptions, I can still use it. I have made hp psc 2410xi photosmart scanner to refill cartridges myself and have been successful until a few months ago. I was very happy with mybut now it will no longer print black or color. I have brought the problem on myself by going the cheap direction. How is the best way to attempt cleaning this machine. Obviously, the cleaning and aligning tools do not work. I assume that you intend to buy a new set of cartridges. If you want to refurb the print mechanism it is necessary to remove the case.Download the latest drivers, firmware, and software for your HP PSC Photosmart All-in-One is HP's official website that will help automatically.

Hp psc photosmart all-in-one FixYourOwnPrinter

Manuals or user guides for your HP PSC Photosmart All-in-One Printer. and use your printer. Learn how to set up your HP Printer, print, scan and fax.

Related Drivers